
So this is one part of my 737 cockpit simulator project. This overhead panel is designed by me and it is printed with 3D Printer. There's lot of to do but I think it's worth it.
Sometime in future I will share all material including measurements and 3D models for free. But not yet, because this is not a final version.
What else I have almost ready is control yokes including whole control system, 737 shaft which was not a quite success but by few modifications is should satisfy, MIP with screens is done very far and computers for instruments.
Idea for this project is to manufacture 737 home simulator with very tight budget and to make these panels available for everyone to print with 3D printer. I also have a very low amount of time to make this ready, so I'm using a lot of time with this.